What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 24.06.2025 00:06

These devices are installed between the “hot” and “neutral” and protective ground.
First Sentence:
This one hit behind the barn.
What is your first experience having sex with older men?
So, the voltage could go up to 500 volts, and the fuse will not open up.
what exactly is a ‘surge’ protector?
He then describes the function of a fuse.
Stock futures fall as investors eye Israel-Iran conflict: Live updates - CNBC
The other is “what does a “fuse” do?”
There are three different concepts here that are getting confused.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Now when you have a certain ac resistance, then a current flows in a loop.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
It seems Mohan does not understand the difference between a comment and an Answer.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
[old diagram got deleted by accident]
What does a fuse do?
But… the neutral is now “floating” because of the 1 ohm resistance.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
[image of Common-mode choke]
Who writes and reads novels nowadays?
Edit 2024–10.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
NASA KSC Announces COMET Staff RIF (Update) - NASA Watch
The MOV will conduct when the voltage exceeds 50% of line voltage.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Is Claude AI better than ChatGPT for Alexa?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
At one ohm, the resistor has a maximum of 1 watt power.
Here is a simplified AC power diagram.
Why would my ex block me after I blocked him?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
I post the exact comment here.
iFixit says the Switch 2 is even harder to repair than the original - The Verge
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is where this question deviates from being a 'generic' question, and becomes more specific.
He then asserts :
Why is it difficult to get a job?
In schematic diagrams this is the symbol for a fuse:
2024–10–14 [Omar Gharbi Omar Gharbi ]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
One
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
He then describes Rainy Season and Lightning.
At least they know the answer if they wanted it.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Because the load is inductive, the current lags the voltage.(by a bit).
Upvotes:
The bolt then partially travels down the line to your home.
a photo is worth a thousand words.
A circuit breaker is similar, but is resettable.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
An AC voltage/ current source, and an ac inductive load.
It also is a device that limits the change in current flow.
eight
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
but I think this circuit , shows a few more pieces.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
This device then solves the entire problem.
But it can get overloaded, and no longer works.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
the problem then depends on "how fast does the fuse operate?".
For this case there are devices called Metal oxide varistors (MOV).
but this device (an Inductor) … impedes the rapid changes in the current.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
What is lightning?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is 'the assistant's answer'
nine
One is “what exactly is in a ‘surge protector’ ? ”
(Dc diagram shown, AC is similar).
The third is lightning and “how it gets conducted into a home.”
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–10[John johnson John Johnson ]
so, what happens?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is where the MOV conducts again, and dissipated the energy.
A fuse is a non-resetable over current circuit protector.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–16 [ OO OLAOYE OYEBODE ]
These are simplified answers to the original question, and does not change anything I wrote above.
Barnstars:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
There are two important concepts here.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]